DVR-LX60D
47
5
6
7
8
5
6
7
8
C
D
F
A
B
E
OSD Filter Setting
OSD FILTER : 4
• While the User Operation screen is displayed, press the then keys, then the
key four times, in that order.
• While subscreen 3 of the first screen is displayed, press the key.
[How to enter]
Press the key.
[How to quit]
ESC
DISP
DIG/ANA
ESC
Depending on the monitor used, the character flicker on the OSD may stand out.
If a system, such as character flicker, appears on the monitor, select the filter response.
[Purpose]
DIG/ANA
[Setting procedures]
1
Display subscreen 4.
2
Select the setting from the key operation table.
[Tips]
As the setting value becomes greater, jitter is reduced on a CRT display. However, as lines for characters appear thick,
complex characters may become difficult to read. On the contrary, as the setting value becomes smaller, jitter
increases on a CRT display. However, as lines for characters become sharper, complex characters become more
legible.
Note: Use the remote control unit for servicing.
Note: A new setting becomes active as soon as it is made. As a new setting is stored in nonvolatile memory, it will be
retrieved when the unit it turned on the next time.
Note: After the factory-preset values are downloaded, the setting value for the OSD Filter will be the default value (4).
Subscreen 4
[Tools to be used]
Remote control unit for servicing
(GGF1381)
[(Table 2) Key operation of OSD Filter setting]
Key
Operation
Setting value
Remarks
0 - 4 (Default value: 4)
[ Rev x 3 ], [SPEED+]
[ x 3 Fwd], [SPEED-]
[ Rev x 3 ], [SPEED+]
: The setting value increases by 1.
[ x 3 Fwd ], [SPEED-]
: The setting value decreases by 1.
Changing the setting value for the
OSD Filter
The setting value is reset to default.
[ESC]
[CLEAR]
–
–
To exit the OSD Filter Setting and
clear the screen
(Appears the tuner
screen.)
–
OSD Filter Setting (Subscreen 4)