#
Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.
DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
2
Tighten two screws on each side.
1
2
3
1
Truss screw (5 mm × 8 mm)
2
Mounting bracket
3
Dashboard or console
Removing the unit
1
Remove the trim ring.
1
Trim ring
2
Notched tab
!
Releasing the front panel allows easier ac-
cess to the trim ring.
!
When reattaching the trim ring, point the
side with the notched tab down.
2
Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3
Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Press the detach button and push the front
panel upward and pull it toward you.
For details, refer to
and
Troubleshooting
Common
Symptom
Cause
Action (Reference page)
The power will not turn on.
The unit will not operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that all connections
are correct.
The fuse is blown.
Rectify the cause and then replace the
fuse. Be sure to install a fuse with the
same rating.
Noise and/or other factors are
causing the built-in microproces-
sor to operate incorrectly.
Turn the unit off and then on. (Page 6)
Operation with the remote
control is not possible.
The unit does not operate cor-
rectly even when the appropri-
ate remote control buttons
are pressed.
Battery power is low.
Load a new battery.
Some operations are prohibited
with certain discs.
Try operating with another disc.
Playback is not possible.
The disc is dirty.
Clean the disc.
The type of disc loaded cannot be
played on this unit.
Check the disc type.
The disc loaded is not compatible
with this video system.
Change the disc to one that is compatible
with your video system.
There is no sound.
The volume level will not rise.
Cables are not connected cor-
rectly.
Connect the cables correctly.
The unit is performing still, slow
motion or frame-by-frame play-
back.
There is no sound during still, slow mo-
tion or frame-by-frame playback.
The
icon is displayed, and
operation is not possible.
The operation is prohibited for
the disc.
This operation is not possible.
The operation is not compatible
with the configuration of the disc.
This operation is not possible.
The image displayed stops
(pauses) and the unit cannot
be operated.
The data could no longer be read
during playback.
Stop playback once, and start playback
again.
There is no sound.
The volume level is low.
The volume level is low.
Adjust the volume level.
The attenuator is on.
Turn the attenuator off.
English
Installation
23
Section
Additional information
En
04
