62
En
Additional Information
8
Picture playback stops and the operation buttons
cannot be used.
• Press
7
, then start playback again (
3
).
• Switch the power off once, unplug from the wall socket,
then plug back in and switch on again using the front
panel
STANDBY/ON
.
New settings made in the Setup screen menus
while a disc is playing are ineffective.
• Some settings can be changed while a disc is playing,
but are not effective until the disc is stopped then
restarted. This is not a malfunction.
Make the same setting when the player is stopped.
Press
7
, then restart playback (
3
). Note that
making settings in the Setup screen menus may
cancel the
RESUME
function.
Settings are canceled.
• When the power is cut due to power failure or by
unplugging the power cord, settings will be canceled.
Press
STANDBY/ON
on the front panel to turn
the player off. Wait for
‘--OFF--’
to disappear from
the display, then unplug the power cord.
No picture/No color.
• Incorrect video connections.
Check that connections are correct and that plugs
are inserted fully.
• TV/monitor or AV amplifier settings are incorrect.
Check the instruction manual of the connected
equipment.
• The
Component Video
menu is set to
Progressive
but
your TV/monitor is not compatible with progressive
scan.
Reconnect the player to your TV using a composite
or S-Video cord and set the TV to the appropriate
input. Now choose the Interlace setting in the
Component Video
menu, then switch the TV input
back to the component input. (
page 48
).
Reset the player (
page 65
). Component Video will
be reset to
Interlace
but you’ll also loose other
settings.
Screen is stretched or aspect does not change.
• The
TV Screen
setting in the Setup menu is incorrect.
Set the
TV Screen
option to match the TV/monitor
you're using (
page 47
).
Troubleshooting
Incorrect operation is often mistaken for trouble
or malfunction. If you think that there is
something wrong with this component, check
the points below. Sometimes the trouble may lie
in another component. Inspect the other
components and electrical appliances being
used. If the trouble cannot be rectified after
checking the items below, ask your nearest
Pioneer authorized service center or your dealer
to carry out repair work.
The disc is ejected automatically after loading.
• Dirty or damaged disc.
See
page 58
for disc care information.
• Disc not seated properly in the disc guide.
Align the disc properly.
• Incompatible region number.
If the region number on a DVD-Video disc does not
match the number on the player, the disc cannot be
used (
page 9
).
• Condensation inside the player.
Allow time for condensation to evaporate. Avoid
using the player near an air-conditioning unit.
Playback is not possible.
• Disc is loaded upside down.
Reload the disc with the label side face up.
• A Super VCD that does not conform with the IEC
standards might not play normally.
Cannot play DVD-RW disc
• If the display shows
‘COPY PROTECT PROGRAM,
UNPLAYABLE’
, this means that this disc cannot be
played.
DVD-Audio playback stops.
• The disc may have been illegally copied.
mark appears on screen.
• The operation is prohibited by the player.
mark appears on screen.
• The selected function does not operate for that disc.
When making changes in the Setup OSD menus,
is displayed.
• There is a CD or Super VCD/Video CD loaded and the
setting that was changed applies only to DVD discs.
The settings will take effect next time a DVD is
loaded.
Summary of Contents for DV-47A Elite
Page 1: ...DVD PLAYER DV S733A DV 47A Operating Instructions ...
Page 2: ...2 En ...
