73
DV-38A, DV-S88A, DV-S838A, DV-939A
7.1.4 TROUBLE SHOOTING
• No Power ON
• FL is not turned ON
• FL indication is unusual
START
Is FL turn on ?
Is tray open ?
Is the indication
of FL normal ?
Do the video and
sound come on ?
Power ON
Yes
Yes
Yes
Yes
No
No
No
Turn on the power again
after 2 - 3 minutes.
• Blow out fuse of the primary side
• Blow out micro-fuse on the POWER SUPPLY Unit. (Check the each voltage.)
(P101, P102, P103)
• Blow out resistor on the POWER SUPPLY Unit. (R104)
• FL controller IC (IC101) on the FLKY Assy is damaged.
• Blow out micro-fuse (P101) on the DVDM Assy.
• Blow out micro-fuse (P103) on the POWER SUPPLY Unit.
• Check the connection between LOSB Assy and DVDM Assy.
(12P flexible cable)
• Check the +8V power supply voltage (above micro fuse).
FL indication is dark or flickers.
No
Indicates the error message
Refer to the section "7.1.5 ERROR CODE".
Indicates the error message
Refer to the section "7.1.5 ERROR CODE".
• Check the following connections :
DVDM Assy - AJKB Assy
DVDM Assy - VJKB Assy
DVDM Assy - DJKB Assy
AJKB Assy - SCRB Assy (WY type)
VJKB Assy - SCRB Assy (WY type)
• Check each voltage (+8V, +12V and 12V)
[If above voltage are not supplied, check the micro-fuse(P101, P102, P103).]
• Check the following connections :
POWER SUPPLY Unit - DVDM Assy
DVDM Assy - FLKY Assy
FLKY Assy - PWSB Assy
• Check each voltage (EV+5V, SW+5V, SW+3.3V, +8V, +12V, -12V and -27V)
(If above voltage are not supplied, check the micro-fuse.)
• Short or open the zenner diode
on the POWER SUPPLY Unit.
(ZD102)
• Check the values of R118 on the FLKY Assy.
• Do not you set FL DIMMER ON ?
OK