8
<DRC1085>
En
7
DC Input
This is the power supply input for DC +5 V and +12 V.
A HARDWARE TOUR
REAR VIEW
Fig. 2
1
2
3 9
4 0
1
1
4
5
2 1
-
0
9
8
7
4
1
Pin
Name
Function
1
+12
Power supply input for DC +12 V.
2
G
Ground.
3
G
Ground.
4
+5
Power supply input for DC +5 V.
Pin
Name
Function
1
L
Left channel audio output.
2
G
Ground.
3
G
Ground.
4
R
Right channel audio output.
Pin
Name
Function
1
GND
Ground.
2
Digital Out
Digital audio signal output.
8
Host IDE Interface
This is a 40 pin I/O connector according to the ATA specifications.
9
Device Configuration Jumper
This is the jumper switch for selection of the drive use mode and supporting PC.
Short-circuit socket is attached for the setting
attached : on
not attached : off
* Only MASTER is ON at the time of shipping from the plant.
0
Audio Output
This is a connector for output of analog audio.
As a Molex 70553 type connecter is used, select a matching connection cable.
-
Digital Audio Output
This is a connector for output of digital audio signal.
Pin
Name
Function
1
MASTER* on The drive is used in master mode.
2
SLAVE
on The drive is used in slave mode.
3
CABLE
on Mode for drive setting by CABLE
SELECT
SELECT of the IDE interface.
4
Reserved.
5
Reserved.
