DJM-707
115
5
6
7
8
5
6
7
8
C
D
F
A
B
E
• Operating screen
1. How to rewrite the program for the system control microcomputer
1
With the DJM-707's power off, connect the DJM-707 and a PC via the special device by connecting it to the connector for
rewriting the program for the system control microcomputer.
2
Turn on the DJM-707.
3
Start up [FLASH.exe], the software for rewriting, on the PC.
4
Assign "3068F.inf" to "Device selection Flash memory block information file."
5
Assign 5 sec to "Timeout duration."
6
Assign "Boot mode" to "Mode selection."
7
Click on "Set".
8
If "Set to Boot mode and restart by resetting" is displayed, click on "OK".
9
The rewriting control program is transferred in 5 seconds.
0
When program transfer is finished, the display in the window disappears.
Select "WRITE" at the upper left of the menu bar.
-
After clicking on Reference, select "mixer_707_xxxx.mot" (or PD3453x8.mot)
for "Filename."
=
Assign "00000000" to "Start address."
~
Assign "0003FFFF" to "End address."
!
Assign "0" to "Offset."
@
Click on "OK".
#
The system control computer program is transferred in 2 min 30 sec.
$
When program transfer is finished, the display in the window disappears.
Select File on the menu bar then Exit to exit the program.
%
Turn off the DJM-707.
^
Disconnect the special device from the DJM-707.
• After rewriting the system control microcomputer, make the setting for the noncontact fader (see 7.1.1 "Service mode").
5
6
7
4
0
8
!
#
$
9
00000000
PD3453x8.mot
0003FFFF
@
-
=
~
3068F.INF
0
3062FA.INF
3067S,INF
3068F.INF
Summary of Contents for DJD-707
