Pioneer DEQ-P7050, Operation Manual

Page: 12 / 40

Audio Adjustments
2 Press
2
or
3
to select the speaker to be
adjusted.
Each press of
2
or
3
selects the speaker in the
following order:
Front speaker left—Center speaker—Front
speaker right—Rear speaker right—Rear
speaker left—Subwoofer
• You cannot select speakers whose size is set
OFF .
3 Press
5
or
∞
to adjust the speaker output
level.
Each press of
5
or
∞
increases or decreases
the speaker output level.
•
+10 — –10 is displayed as the level is
increased or decreased.
4 Press BAND/ESC to return to the playback
display.
Note
• To adjust the speaker output levels at this
mode is the same as making the speaker
output levels at
T Tone . Both provide the
same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Press AUDIO and hold until SP Set
appears in the display, then press AUDIO to
select T Tone.
After SP Set is displayed, press AUDIO until T
Tone appears in the display.
2 Press
3
to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence at
intervals of about 2 seconds. The current set-
tings for the speaker over which you hear the
test tone are shown in the display.
Front speaker left—Center speaker—Front
speaker right—Rear speaker right—Rear
speaker left—Subwoofer
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
• The settings do not appear for speakers
whose size is set
OFF .
3 Press
5
or
∞
to adjust the speaker output
level.
Each press of
5
or
∞
increases or decreases
the speaker output level.
•
+10 — –10 is displayed as the level is
increased or decreased.
• The test tone rotates to the next speaker after
about 2 seconds from the last operation.
4 Press
2
to stop the test tone output.
5 Press BAND/ESC to return to the playback
display.
Notes
• If needed, select speakers and adjust their
‘absolute’ output levels, see Adjusting the
speaker output levels on page 11.
• To adjust the speaker output levels at this
mode is the same as making the speaker
output levels at
SP Lev . Both provide the
same results.
En 12
02
Section