Pioneer DEH-X6800BT, Owner'S Manual

Page: 17 / 84

17
En
En
g
lis
h
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*3 Not available when [OFF] is selected in [SUB.W].
You can also access to these menus when the unit is turned off.
LOUDNESS
[OFF], [LOW], [MID], [HI] Compensate for clear sound at low volume.
SUB.W *2
[NOR], [REV], [OFF] Select the subwoofer phase.
SUB.W CTRL *2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6] Select the bass boost level.
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4] Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
• USB, iPod, PANDORA (iPhone), ANDROID, and
APP (iPhone)
• BT AUDIO, PANDORA (Android), ANDROID, and
APP (Android)
SYSTEM settings
Menu Item Description
CLOCK SET
Set the clock (page 5).
Menu Item Description
12H/24H
[12H], [24H] Select the time notation.
INFO DISPLAY (Not available for DEH-X4800BT/X4810BT)
Display the item on the sub information display.
Select from “SPEANA”, “LEVEL METER”, “SOURCE”,
“CLOCK”, and “OFF”.
AUX
[ON], [OFF] Set to [ON] when using an auxiliary device
connected to the unit.
USB AUTO
[ON], [OFF] Select [ON] to automatically switch to [USB]
source when a USB device/iPod is connected to
the unit.
Select [OFF] when a USB device/iPod is being
connected to the unit just for charging.
BT AUDIO
[ON], [OFF] Set the Bluetooth signal on/off.
BT MEM CLEAR
[YES], [CANCEL] Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.
BT VERSION
Displays the system version of the unit and the
Bluetooth module.
APP CONN.SET
[WIRED], [BLUETOOTH] Select the appropriate connection method
according to your device.
ANDROID WIRED
[MEMORY], [APP CONTROL] Select the appropriate connection method for an
Android device.
P.APP AUTO ON
[ON], [OFF] Select [ON] to automatically launch the car remote
application when an Android device is connected
to the unit via AOA. (Not available when
[MEMORY] is selected in [ANDROID WIRED].)
Menu Item Description