Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select Loud.
Press
AUDIO
until
Loud
appears in the dis-
play.
2 Press
a
to turn loudness on.
Loudness level (e.g.,
Loud Mid
) appears in the
display.
3 Press
c
or
d
to select a desired level.
Each press of
c
or
d
selects level in the fol-
lowing order:
Low
(low)
Mid
(mid)
High
(high)
4 Press
b
to turn loudness off.
Loud OFF
appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press AUDIO to select Sub-W1.
Press
AUDIO
until
Sub-W1
appears in the dis-
play.
#
When the subwoofer controller setting is
PREOUT :FULL
, you cannot select
Sub-W1
.
2 Press
a
to turn subwoofer output on.
Sub-W1 Normal
appears in the display. Sub-
woofer output is now on.
#
To turn subwoofer output off, press
b
.
3 Press
c
or
d
to select the phase of sub-
woofer output.
Press
c
to select reverse phase and
Rev.
ap-
pears in the display. Press
d
to select normal
phase and
Normal
appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO to select Sub-W2.
Press
AUDIO
until
Sub-W2
appears in the dis-
play.
#
When the subwoofer output is on, you can se-
lect
Sub-W2
.
2 Press
c
or
d
to select cut-off frequency.
Each press of
c
or
d
selects cut-off frequen-
cies in the following order:
50
80
125
(Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3 Press
a
or
b
to adjust the output level
of the subwoofer.
Each press of
a
or
b
increases or decreases
the level of the subwoofer.
+6
6
is displayed
as the level is increased or decreased.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit
s
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1 Press AUDIO to select non fading out-
put on/off setting.
Press
AUDIO
until
NonFad ON
appears in the
display.
#
When the subwoofer controller setting is only
PREOUT :FULL
, you can switch to the non fading
output on/off setting. (Refer to page 39.)
2 Press
a
to turn non fading output on.
NonFad ON
appears in the display. Non fad-
ing output is now on.
#
To turn non fading output off, press
b
.
Audio Adjustments
En
34
Section
08
HHHHHHHHHHHHHH
Summary of Contents for DEH-P6500R
Page 105: ...Es 105 Español HHHHHHHHHHHHHH ...
Page 106: ...Es 106 HHHHHHHHHHHHHH ...
Page 107: ...Es 107 Español HHHHHHHHHHHHHH ...
