2
Use MULTI-CONTROL to select
Face auto open.
3
Press MULTI-CONTROL to turn the face
auto open on.
#
To turn the face auto open off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 35.
!
For this function, verify the topic
Adjusting
initial settings
before initiating the opera-
tion.
1
Display the intial setting menu.
2
Use MULTI-CONTROL to select AUX1/
AUX2.
3
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
!
For this function, verify the topic
Adjusting
initial settings
before initiating the opera-
tion.
1
Display the intial setting menu.
2
Use MULTI-CONTROL to select Dimmer.
3
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness.
!
For this function, verify the topic
Adjusting
initial settings
before initiating the opera-
tion.
1
Display the intial setting menu.
2
Use MULTI-CONTROL to select
Brightness.
3
Push MULTI-CONTROL left or right to
adjust the brightness level.
0
to
15
is displayed as the level is increased or
decreased.
#
When dimmer is functioning, the brightness
level can be adjusted
0
to
10
.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range
) or subwoo-
fer (
Rear SP :S/W
) connection. If you switch
the rear output setting to
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range
).
!
For this function, verify the topic
Adjusting
initial settings
before initiating the opera-
tion.
1
Display the intial setting menu.
2
Use MULTI-CONTROL to select
S/W control.
3
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL
will switch be-
tween
Rear SP :F.Range
(full-range speaker)
and
Rear SP :S/W
(subwoofer) and that status
will be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :F.Range
.
Initial Settings
En
31
Section
04
Initial
Settings