Black plate (29,1)
1
Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to
Adjusting initial settings
on page 27.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select Dimmer
in the initial setting menu.
Refer to
Adjusting initial settings
on page 27.
2
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness.
1
Use MULTI-CONTROL to select
Brightness in the initial setting menu.
Refer to
Adjusting initial settings
on page 27.
2
Push MULTI-CONTROL left or right to
adjust the brightness level.
0
to
15
is displayed as the level is increased or
decreased.
#
When dimmer is functioning, the brightness
level can be adjusted
0
to
10
.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range
) or subwoo-
fer (
Rear SP :S/W
) connection. If you switch
the rear output setting to
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range
).
1
Use MULTI-CONTROL to select
S/W control in the initial setting menu.
Refer to
Adjusting initial settings
on page 27.
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL
will switch be-
tween
Rear SP :F.Range
(full-range speaker)
and
Rear SP :S/W
(subwoofer) and that status
will be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :F.Range
(full-range speak-
er).
#
When a subwoofer is connected to the rear
output, select
Rear SP :S/W
(subwoofer).
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
25).
!
If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
!
Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
<
QRD3028-A/N
>29
Initial Settings
En
29
English
Section
04
