1
Use MULTI-CONTROL to select Clock in
the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing
MULTI-CONTROL
left or right will se-
lect one segment of the clock display:
Hour
—
Minute
As you select segments of the clock display,
the selected segment blinks.
3
Push MULTI-CONTROL up or down to
put a clock right.
Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL
.
!
If
00
to
29
, the minutes are rounded down.
(e.g.,
10:18
becomes
10:00
.)
!
If
30
to
59
, the minutes are rounded up. (e.g.,
10:36
becomes
11:00
.)
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Use MULTI-CONTROL to select
Warning tone in the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 33.
1
Use MULTI-CONTROL to select AUX1/
AUX2 in the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select Dimmer
in the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness.
1
Use MULTI-CONTROL to select
Brightness in the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Push MULTI-CONTROL left or right to
adjust the brightness level.
0
to
15
is displayed as the level is increased or
decreased.
#
When dimmer is functioning, the brightness
level can be adjusted
0
to
10
.
Initial Settings
En
29
English
Section
04
