!
If
00
to
29
, the minutes are rounded down.
(e.g.,
10:18
becomes
10:00
.)
!
If
30
to
59
, the minutes are rounded up.
(e.g.,
10:36
becomes
11:00
.)
4
Push MULTI-CONTROL up or down to
put a clock right.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
!
If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select FM STEP
in the initial setting menu.
3
Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
#
The tuning step remains at 50 kHz during
manual tuning.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select AM STEP
in the initial setting menu.
3
Press MULTI-CONTROL to select the AM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the AM tuning step between 9 kHz and
10 kHz. The selected AM tuning step will ap-
pear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select
WARNING in the initial setting menu.
3
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
It is possible to use auxiliary device with this
unit. Activate the auxiliary setting when using
auxiliary device connected to this unit.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select AUX in
the initial setting menu.
3
Press MULTI-CONTROL to turn AUX on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Initial Settings
En
41
English
Section
10
