This unit is equipped with a subwoofer output which
can be turned on or off.
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to select the desired setting.
Normal
(normal phase)
—
Reverse
(reverse
phase)
—
OFF
(subwoofer off)
3
Press
M.C.
to confirm the selection.
SW setting 2
(subwoofer adjustment)
When the subwoofer output is on, you can adjust the
cut-off frequency and the output level of the subwoo-
fer.
Only frequencies lower than those in the selected
range are outputted from the subwoofer.
1
Press
M.C.
to display the setting mode.
2
Press
M.C.
to cycle between cut-off frequency and
output level of subwoofer.
3
Press
M.C.
to switch to cut-off frequency and then
turn
M.C.
to select cut-off frequency.
50Hz
—
63Hz
—
80Hz
—
100Hz
—
125Hz
4
Press
M.C.
to switch to output level and then turn
M.C.
to adjust output level.
Adjustment range:
+6
to
-24
HPF setting
(high pass filter adjustment)
When you do not want low sounds from the subwoo-
fer output frequency range to play from the front or
rear speakers, turn on the HPF (high pass filter). Only
frequencies higher than those in the selected range
are output from the front or rear speakers.
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to select cut-off frequency.
OFF
(off)
—
50Hz
—
63Hz
—
80Hz
—
100Hz
—
125Hz
3
Press
M.C.
to confirm the selection.
Bass booster
(bass boost)
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to adjust the level.
Adjustment range:
0
to
+6
3
Press
M.C.
to confirm the selection.
SLA
(source level adjustment)
SLA
(Source level adjustment) lets you adjust the vo-
lume level of each source to prevent radical changes
in volume when switching between sources.
!
When selecting FM as the source, you cannot
switch to
SLA
.
!
Settings are based on the FM volume level, which
remains unchanged.
Before adjusting source levels, compare the FM
volume level with the level of the source you wish
to adjust.
!
The AM volume level can also be adjusted with
source level adjustments.
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to adjust the source volume.
Adjustment range:
+4
to
–
4
3
Press
M.C.
to confirm the selection.
Note
Operation is complete even if the menu is can-
celled before being confirmed.
Initial Settings
Important
Power save mode is cancelled if the vehicle bat-
tery is disconnected and will need to be turned
back on once the battery is reconnected. When
power save is off, depending on connection meth-
ods, the unit may continue to draw power from
the battery if your vehicle's ignition switch doesn't
have an ACC (accessory position).
1
Press SRC/OFF and hold until the unit
turns off.
2
Press SRC/OFF and hold until the initial
setting menu appears in the display.
3
Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
Operating this unit
En
15
English
Section
02
