Setting up the receiver
06
52
En
The test tone for channel delay is output in the
same order as step 5:
After you have completed all the channels in
your speaker setup, the volume level returns
to normal and
COMPLETE
, then
RESUME
shows in the display.
• Using the MCACC system to set up your
speaker system will overwrite any
previous settings you had for the
STANDARD
or
ADVANCED SURROUND
modes.
Setting separate channel
levels for listening modes
• Default setting:
0 dB
In addition to the MCACC setup, you can also
set relative channel levels from the listening
position using the method below. Using
CH
SELECT
(see tip below), it is also possible to
set separate channel levels for each of the
listening modes.
1
Press STANDARD or ADVANCED
SURROUND.
2
Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
• If you don’t hear a test tone from one of
your speakers, please refer to
Speaker
setting
on page 45 and
Surround back
speaker setting
on page 46 to make sure
you have correctly specified your speaker
setup.
R
C
RS
LS
SW
SB
STANDARD SURROUND
ADVANCED
LEVEL
TEST
TONE
MASTER
VOLUME
CH
SELECT
L
C
RS
R
LS
SW
SB
