4
En
2
Securing the pillar onto the stand base.
While the pillar is fitted into the stand base, slowly place the stand
onto the groove of the cushioning material (places indicated in the
accompanying illustration) so that the rear side of the stand faces
upwards (securely hold both the pillar and the stand base when
doing this).
• Pillar and base for CP-LX70
• Pillar and base for CP-LX70TS
From the bottom side of the stand base, secure the pillar to the
stand base by screwing in 4 supplied screws (small).
3
Adjust the length of the speaker cable.
Adjust the length of the speaker cable to suit the height at which
the speaker is going to be installed. Viewing the height scale on the
backside of the pillar, adjust the length of the exposed speaker
cable using the following numbers as reference:
Scale: 0
Approx. 11 cm (4.3 in.)
Scale: 100 Approx. 15 cm (5.9 in.)
Scale: 170 Approx. 22 cm (8.7 in.)
• To shorten the speaker cable, adjust the length by pulling the
additional cable in the pillar from the hole in the bottom of the
stand base, and then push that extra cable into the hole where
the right or left cable passes, as shown in the illustration. If all
of the extra cable cannot be pressed into the hole, store the
remainder of the cable in the open space on the bottom of the
stand base.
Rest pillar here
Hold both pillar and stand base
Cushioning
material (Bottom)
Rest pillar here
Hold both pillar and stand base
Screws (small)
Height scale
Exposed speaker
cable length
Backside
of pillar
(When making the cord shorter)
01_CP-LX70_EU.book 4 ページ ２００７年９月５日 水曜日 午前１０時５１分
