66
Setting the Input Selection
1 Set the input selection switch on the front of the loudspeaker to the
△
symbol.
2 The illustration shows a 60 W setting when the CM-C56T is
connected to a 100 V line and a 30 W setting when connected to a 70
V line.
CM-C56T
CM-C54T
100 V
70 V
100 V
70 V
A
16Ω 60 W
16Ω 30 W
B
OFF
C
---
60 W
---
30 W
D
60 W
30 W
30 W
15 W
E
30 W
15 W
15 W
7.5 W
F
15 W
7.5 W
7.5 W
3.7 W
CAUTION
•
Use position A only when the loudspeaker is used with a low impedance amplifier.
The loudspeaker and power amplifier may be damaged if the setting is wrong.
•
Turn off the power to the power amplifier before working.
Attaching the Panel
1 Fit the panel onto the loudspeaker by aligning the
△
symbol
1
on
the front of the loudspeaker with the position of the
△
symbol
2
on
the back of the panel, and then push it and turn it clockwise.
CAUTION
The panel may fall off if it is not sufficiently fit onto the loudspeaker. Firmly turn the
panel until it bites into the serration
3
.
2 Fasten the panel in the area where the serration
3
makes a noise
3 To remove the panel, twist it counterclockwise.
1
x4
2
x4
3
Trademarks and Registered Trademarks
"Pioneer DJ" is a trademark of Pioneer Corporation and used under license.
© 2019 Pioneer DJ Corporation. All rights reserved.
