12
BDP-170
1
2
3
4
A
B
C
D
E
F
1
2
3
4
4. EACH SETTING AND ADJUSTMENT
4.1 NECESSARY ITEMS FOR ADJUSTMENTS
[How to read and write the barcode data to the unit]
In addition to the two conventional methods of reading/writing barcode data, a new method using a USB memory device has been added.
It is recommended to use the new method if you have a USB memory device, because with this method setting is easier and input errors
will be less likely to be generated.
For details on the conventional methods (with the aid of the remote control unit or a combination of a PC and a special tool for servicing),
refer to the Service Manual of the BDP-160. (No change has been made regarding the procedures of those conventional methods and
connector placement.)
Please perform either method when replacing MAIN BOARD Assy or LOADER Assy.
USB memory device (one that can be
recognized in Normal Operation mode)
3
It is easy to read and write the barcode data.
It is necessary to prepare a USB memory device.
Note:
• Change the Destination setting after MAIN BOARD Assy is replaced. After that, update the latest firmware.
• Please confirm that the USB memory device is recognized after inserting the USB memory device to the USB port.
(Due to protect wrong connection)
Note:
Be sure to update the firmware before starting adjustments or settings.
——————————
This time
Adjustment Points
Adjustment Points
[1] When replace the LOADER Assy
Mechanical
point
Write barcode data for pickup adjustment
Electric
point
When replace
the LOADER Assy
——————————
This time
[2] When replace the MAIN BOARD Assy
Mechanical
point
• Read out barcode data for pickup adjustment
(Before replacing MAIN BOARD Assy)
• Write barcode data for pickup adjustment
(After replacing MAIN BOARD Assy)
Electric
point
When replace
the MAIN BOARD Assy
[About barcode data for pickup adjustment]
A new LOADER Assy is installed in this model and it has 64 bit barcode data for pickup adjustment.
Therefore when replacing a new LOADER Assy, it is necessary to write barcode data of the new LOADER Assy.
The barcode data is stored in a MAIN BOARD Assy. Therefore when replacing the MAIN BOARD Assy, it is necessary to
read out the original barcode data before replacing it and write the data to a new MAIN BOARD Assy after installing it.
Necessary tools
Good Point
Bad Point
Remote control unit
1
It is not necessary to prepare other tools such as
Service jig and PC.
Need to enter 64 letters barcode data by using
a Remote control unit.
Service jig (GGF1676), PC,
Driver and Read/Write program
2
It is very easy to read and write the barcode data.
It is necessary to prepare other tools such as
Service jig and PC.
(But Service Jig is very cheap.)
[Attention point when replacing MAIN BOARD Assy]
When the unit is no power condition due to defective of a MAIN BOARD Assy, original barcode data is not able to read
out from it. In such a case, read out the data of the barcode label attached to the BD LOADER, referring to the SKT15002
Service Knowhow manual.
