7
<BRB1057>
ACTION
Connect cable service to BD-V1000
CABLE IN (input connector).
¶
If TV has video and stereo audio
inputs:
Follow the
Stereo Connection
diagram on page 6. Connect BD-
V1000 L/R AUDIO OUT and VIDEO
OUT to the corresponding IN jacks
on the TV, using shielded RCA
(phono) jumper cables.
If TV VIDEO IN is a 4-pin S-Video
jack, connect BD-V1000 S-VIDEO
OUT to TV S-VIDEO IN using a
special S-Video jumper cable.
Leave BD-V1000 VIDEO OUT
unconnected.
¶
If TV has no video/audio inputs:
Follow the
Simple Connection
diagram on page 6. Connect BD-
V1000 TO TV (output) connector to
the TV VHF ANTENNA INPUT.
If TV VHF ANTENNA INPUT is a
300-ohm twin-lead (with two
screws), then use a 75 ohm - 300
ohm adapter.
Plug TV AC cord into BD-V1000 AC
outlet.
Plug BD-V1000 AC cord into an AC
outlet that is not controlled by a switch.
STEP
1
2
3
4
ACTION
¶
If you used the
Simple
Connection
method:
Tune TV to channel 3 or 4.
Other documentation that came
with your BD-V1000 may explain
how to switch the BD-V1000
output channel between 3 and 4.
¶
If you used the
Stereo
or
VCR
Connection
method:
Select the A/V (Audio/Video)
input setting on your TV.
Use your remote control’s TV
POWER button to turn the TV on
and off.
Exception:
TV sets without remote control can
be turned on through the BD-
V1000. Leave the TV power switch
on. Use the on-screen menu to
change the BD-V1000’s outlet from
UNSWITCHED to SWITCHED. Use
the BD-V1000 front panel or
remote control POWER button to
turn the TV on and off.
STEP
1
2
CABLE TV RECEPTION
CONNECTION PROCEDURES
Connect your equipment as shown in the figures
on page 6. Use the first table if you are only
connecting the BD-V1000 to a TV.
ACTION
Follow the
VCR Connection
diagram on page 6. Connect cable
service to BD-V1000 CABLE IN
(input connector).
Connect BD-V1000 outputs to VCR
inputs using the same criteria and
procedures as in step 2 of the table
above for TV connection.
Connect the VCR outputs to the TV
inputs, again using the same
criteria and procedures.
Connect TV AC cord to BD-V1000
AC outlet.
Connect VCR and BD-V1000 AC
cords to AC outlets that are not
controlled by a switch.
STEP
1
2
3
If you have a VCR, follow the procedure below to
connect it between the BD-V1000 and the TV:
4
5
NOTE:
When disconnecting the BD-V1000, follow these
steps in reverse order. Be sure to unplug the BD-
V1000’s power cord first.
SETTING UP THE TV
Follow the steps in the table to set up your TV for
cable.
TURNING OFF THE BD-V1000
To turn off the BD-V1000 home terminal, press the
CBL POWER button on the remote control, or the
POWER button on the BD-V1000.
You can use your remote’s TV POWER button to
turn TV on/off if you have set up the remote with
the correct TV code.
VCR RECORDING
The BD-V1000 has an optional VCR Commander
that lets you automatically record programs.
Please refer to the separate VCR Commander
manual for installation instructions.
