Pioneer AVIC-F10BT, Service Manual

Page: 147 / 337

AVIC-Z110BT/XN/UC
147
5 6 7 8
5 6
7
8
C
D
F
A
B
E
1
2
3
4
1
Fig.5
-
Removing the Monitor Unit(Fig.5)
Disconnect the Cord Assy
using GGF1539.
Disconnect the two cables
and then remove the Grille Unit.
Disconnect the two cables.
Remove the five screws
and then remove Monitor Unit.
Attention at assembly)
The BT Module connects in the upper connector
and the Cord Assy for antenna connects in the under connector.
-
Removing the Keybord Unit (Fig.6, 7)
Attention at assembly)
Cord Assy is a thing set in
the ditch in the Grille Unit.
Attention when the Keyboard Unit
are exchanged.(Fig.7)
• Bend the cable of a broken line part.
• Don’t bend it while rubbing right and left.
Fig.7
_
Refer to figure for how to bend the Cable.
_
Notes after exchanges.
• Lighting confirmation of all LED
• All switch operation confirmations
• Connected confirmation of Bluetooth
The following items after the Keyboard Unit
are exchanged are checked.
The flat screwdriver is hung
and the Keybord Unit removes.(Fig.6)
Fig.6
Monitor Unit
Grille Unit
1
2
2
1
Keyboard Unit