6
Plug the microphone into the micro-
phone input jack on this unit.
(AVH-P4200DVD)
(AVH-3200DVD/AVH-3200BT)
7
Touch Start to start auto EQ.
8
When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
When auto EQ is completed,
Complete
is dis-
played.
When the car
’
s interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to
standing auto EQ/auto TA and EQ error mes-
sages
#
It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
#
To stop auto EQ, touch
Stop
.
#
To cancel auto EQ measurement mode during
this procedure, touch the following touch panel
key.
Canceling auto EQ measurement
mode.
9
Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
10 Press
h
(eject) to close the panel.
(AVH-P4200DVD only)
Note
(AVH-P4200DVD)
Do not press
h
(eject) to open or close the panel
when you are using the microphone.
Correcting distorted sound
(Function of AVH-P4200DVD)
When listening to a CD or other source on
which the recording level is high, setting the
level of each frequency to high may result in
distortion. You can switch the digital attenua-
tor to low to reduce distortion.
!
Sound quality is better at the high setting
so this setting is usually used.
1
Display the system menu.
Refer to
Introduction of menu operations
2
Touch Digital ATT.
3
Touch Digital ATT on the system menu
to select the digital attenuator level.
High
—
Low
Resetting the audio functions
(Function of AVH-P4200DVD)
You can reset all audio functions.
1
Display the system menu.
Refer to
Introduction of menu operations
2
Touch Audio Reset.
En
69
Section
13
Menu
operations
Menu operations
