—
The reflected sound within the car is
strong and delays occur.
—
The LPF on active subwoofers or exter-
nal amps delay the lower sounds.
!
Auto EQ changes the audio settings as fol-
lows:
—
The fader/balance settings return to the
center position. (Refer to
—
The equalizer curve switches to
Flat
.
(Refer to
—
The front, center and rear speakers will
automatically be adjusted to a high
pass filter setting.
!
Previous settings for auto EQ will be over-
written.
Performing auto EQ
1
Stop the car in a place that is quiet,
close all the doors, windows and sun roof,
and then turn the engine off.
If the engine is left running, engine noise may
prevent correct auto EQ.
2
Fix the optional microphone in the cen-
ter of the headrest of the driver
’
s seat, fa-
cing forward.
The auto EQ may differ depending on where
you place the microphone. If desired, place
the microphone on the front passenger seat to
carry out auto EQ.
3
Turn the ignition switch to ON or ACC.
If the car
’
s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
EQ.
4
Display the system menu.
Refer to
Introduction of menu operations
5
Touch Auto EQ Measurement to enter
auto EQ measurement mode.
6
Plug the microphone into the micro-
phone input jack on this unit.
(AVH-P4490BT/AVH-P3490DVD)
(AVH-2490BT/AVH-1490DVD)
7
Touch Start to start auto EQ.
8
When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
When auto EQ is completed,
Complete
is dis-
played.
When the car
’
s interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to
standing auto EQ error messages
#
It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
#
To stop auto EQ, touch
Stop
.
<CRB3743-A/N>68
En
68
Section
12
Menu operations