Pop-Up Drain Installation
Remove the pop-up stopper (E) and pop-up flange (F) from the pop-up
1.
assembly.
Apply adequate amount of plumbers putty underside of pop-up flange (F)
2.
then insert pop-up drain assembly from underside of the sink and secure the
pop-up flange (F) from the top.
Rotate the drain body so that horizontal rod hole faces back of the faucet.
3.
Hold the pop-up assembly in place and tighten the locknut (G).
Remove the excess putty. Connect the trap (H) (check manufacturer’s instruc
-
4.
tions for installation).
Remove rod nut (I).
5.
Ensure the washer (K) is in place (for brass pop-up only). Insert rod (J). Tighten
6.
the rod nut (I).
Push rod down to open drain. Insert the pop-up stopper (E) carefully. Test if the
7.
pop-up stopper (E) is working properly.
Connect pop-up bracket to the rod using clip (L). Tighten the thumbscrew (M)
8.
to connect pop-up bracket to pop-up lift rod.
4
Main Supply Connection
Connect the faucet shank to inlet supply lines (N). Connect the supply stops
•
(O) to the inlet supply lines (N) (left is hot water supply and right is cold water
supply). Make sure inlet supply lines (N) are securely tighten. Do not overtight
-
en.
Turn on water. Check for any leaks. Make sure all the connections are secure.
•
Remove aerator (P).
•
Open the handle.
•
Flush and allow water to run at full flow for at least one minute.
•
Replace aerator (P).
•
For more care information or trouble shooting inquiries about your
Pioneer product, please see the contact information on the back page.
5
