En
12
Adjusting anti-skating
This adjustment is made to prevent stylus jumping.
Match to the same scale position as the stylus pressure
value.
Turn the [
ANTI SKATING
] dial to match the reference line to the same
value as the cartridge stylus pressure value.
When scratch play is performed
To prevent stylus jumping, adjust the scale position to match the play
action.
Adjusting the arm lifter height
When using other than the included cartridge, adjust this to match the
cartridge to be used.
Prepare as follows.
!
A record is placed on a slip mat.
!
Remove the stylus cover and arm clamper while paying attention not
to touch the stylus tip.
!
Pull up the lifter lever and move the tone arm onto the record.
Adjust the height by turning the screw while the arm
lifter is pushed down.
—
Turing clockwise narrows the distance between the record and
stylus.
—
Turing counterclockwise widens the distance between the record
and stylus.
!
The arm lifter height (the distance between the record and stylus
when the lifter lever is pulled up) is factory-adjusted in a range
between approximately 8 mm and 13 mm.
Screw
Arm lifter
Adjusting the arm height
When using the included cartridge, the “
0
” position is appropriate.
When using other than the included cartridge, adjust this to match the
cartridge to be used.
1 Turn the [HEIGHT ADJUST] lock to unlock the lock.
Unlock
2 Push down the lifter lever and place the stylus on the
record, then adjust the [HEIGHT ADJUST] dial to make
the tone arm and record parallel.
Adjust so that the tone arm becomes horizontal.
[
HEIGHT ADJUST
] dial
3 Turn the [HEIGHT ADJUST] lock to fix the height of
the arm.
After adjusting height of the arm, always turn the [
HEIGHT ADJUST
]
lock to fix the arm.
