MAINTENANCE
11
STEP
1
Discharge remaining paint through drain hose (supplied with
unit) into clean container. Cap container tightly for next use.
STEP
2
Shut off gas engine.
STEP
3
Release pressure in the paint tank with brass bleed-off valve.
WARNING: NEVER USE ANY TOOL TO REMOVE PUMP IF
THERE IS PRESSURE IN THE TANK. FAILURE TO FOLLOW
THESE INSTRUCTIONS MAY RESULT IN PERSONAL
INJURY OR DAMAGE.
STEP
4
Remove Pump Assembly. Hose the inside of the tank to remove
any excess paint. Fill tank 3/4 full with water and Pioneer P.H.D.
Solution. Scrub inside of paint tank with soft nylon bristle
brush, available through Pioneer, Item # TBrush.
STEP
5
Replace pump assembly and lock in place.
STEP
6
Start gas engine and pressurize tank to proper operating
pressure, or use hand pump.
STEP
7
Discharge water and P.H.D. Solution through adjustable spray
box, alternating to hand hose (if hand hose was used) until
tank is empty.
STEP
8
Shut off engine – release pressure in paint tank.
SEE STEP 3 ABOVE.
STEP
9
Remove pump assembly and fill paint tank 1/4 full of clean
water. Replace pump assembly and lock in place.
STEP
10
Start gas engine and pressurize tank to proper pressure.
STEP
11
Discharge water through adjustable spray box and hand hose
(if used) until tank is empty.
REPEAT ABOVE STEP UNTIL
WATER COMES OUT CLEAR.
Continued on next page.
Clean-Up of the Tank Unit:
