Staff Duress Pendant (0510-0332-C) - User Guide
7
Chapter 2
Maintenance
Replacing the Pendant Battery
The Staff Duress Pendant uses two AAA 1.5v lithium batteries. The battery holders are
found in the rear of the Pendant, on both sides of the circuit board.
To replace the batteries in the Pendant
1. Use your fingers or plastic tool to pray open the back cover of the Pendant. There
is a small notch in the casing to allow for opening the back cover.
2. If changing the batteries, use a small, non-conductive piece of plastic or wood to
pop the battery free from the battery holder.
N
OTE
: Do not use a metal screwdriver or metallic instrument to remove the
battery. This May damage the device.
3. Press the red button a few times ensure no charge is remaining in the circuits.
4. Insert each battery into its battery holder. Be sure to align the positive (+) end of
the battery as marked on the battery and battery holder.
5. Verify LED light communication.
6. Snap the back cover back onto the Pendant.
7. Dispose of the old lithium battery according to your federal, state and local
guidelines.
