8
9.
MAC Cable Installation
This section of the instructions is for SPIKE
and SPIKE 2.
Route the PP4MAC remote cable over the top
of the coin slot as shown below. Continue down
to the system control panel buttons.
Clip the tie-wrap in the upper left corner of the
coin door to allow more cable slack to the
control buttons.
The MAC cable has a small Printed Circuit board
with connectors mounted to it. The PCB is
inserted in line with the cable going to the coin
door pushbuttons as shown below.
If your coin door does not have the inline connector
shown above then please contact us for a Posi-tap
adapter. Exported SPIKE systems usually do not have
the connector and will need the adapter BUT there
