Pinion C-Line C1.12, Owner'S Manual

Page: 31 / 36

InstallatIon work
31
1.
2.
3.
4.
6.
10 N·m (89 lbf·in) max.
T30
5.
38
1
reMovIng gearbox
www.pinion.eu
Î Î
remove the cable box – see
(fig. 14)
, page 18 – do not remove shifting cables.
danger of injury if the gearbox drops down – approx. 2.1 kg (5 lb) weight.
Î –
get a helper to secure the gearbox during removal.
Î Î
initially only loosen the 2 middle retaining screws.
Î Î
unscrew the 4 upper and lower retaining screws.
Î Î
get a helper to secure the gearbox.
Î
Î
unscrew the 2 middle retaining screws.
Î Î
if necessary, tap the right and left sides of the input shaft alternately with a rubber mallet and
remove the gearbox downwards from the gearbox interface of the bicycle frame.
the gearbox retaining screws are allowed to be reused – providing they have been
cleaned and have fresh screwlock (medium-strength) applied to them.
3.
6.
5.
4.
T30
2.
1.
39
stainless steel screws will cause corrosion on the gearbox housing.
Î –
use original pinion screws exclusively.
the gearbox retaining screws are allowed to be reused – providing they have been
cleaned and have fresh screwlock (medium-strength) applied to them.
Î
Î
make sure that all contact points between the gearbox and gearbox interface of the bicycle frame
are clean and coated with carbon assembly paste (e.g.
DYNAMIC ).
Î
Î
position gearbox in the gearbox interface of the bicycle frame.
Î
Î
install all 6 retaining screws.
Î
Î
tighten retaining screws in the specified sequence with a tightening torque of 10 n·m (89 lbf·in).
(fig. 38)
•
•
the installation of the gearbox is complete.