WHAT TO EXPECT
The Solidgrip™ Pro NST-16EU is a Qi-enabled charger and holder for smartphones.
This means that smartphones that are compatible with the Qi-standard can automatically
charge when placed in the holder. Smartphones that do not yet support Qi wireless
charging will not charge when placed on the mount. This product supports fast charging.
CABLE AND USB-CONNECTION
A USB-A to USB-C cable is provided to power the wireless charger
from a standard USB port. Make sure a free USB charge port
is available in your car. Alternatively, you can use a commonly
available 12V to 5V USB power adapter.
This product is capable of wireless fast-charging your smartphone
when connected to a fast-charging capable power supply.
Connect the Solidgrip™ Pro NST-16EU cable to a fast-charger
compatible with your phone to use wireless fast-charging.
Output depends on the power source and device (iOS 7.5 watts
wireless charging /Android 10 watts wireless charging).
POSITIONING YOUR PHONE
The position of the phone on the mount
is important and depends on the size
of the phone. The wireless charging
module in your smartphone needs to
align with its counterpart in the charger.
You can adjust the vertical position of
your phone by adjusting the phone
support. Finding the correct position
may require some trial and error.
General recommendations
Smartphones <153 mm: phone support up
Smartphones >153 mm: phone support down
OPENING AND CLOSING
The phone holder clamps will automatically close when you
place your Qi-enabled smartphone in the holder. For non-Qi
smartphones, the side buttons on the holder may be used.
The holder can also be opened with these side buttons.
Tip: thanks to the integrated capacitors, the clamps can still be
opened for a short time after shutting down your car engine.
LED INDICATOR
- RED light:
standby/not charging
- BLUE light:
charging
- BLINKING light:
connecting
INSTALLING A MOUNT
The Solidgrip™ Pro comes with two types of mounts:
• The extendable suction cup mount is suitable for mounting
the Solidgrip Pro™ on your windshield or other smooth
surfaces. Use the lever to tighten or loosen the suction cup.
Two knobs are provided to adjust the angle of the mount and
to extend the mount.
• The air vent mount is for attaching the Solidgrip™ Pro to an
air vent. The air vent mount can be clipped onto one of the air
vents in your cabin. Use the integrated support to keep the
holder in the desired position.
* Not all air vent layouts are compatible as designs diff er per car model.
Use the air vent mount at your discretion.
Unscrew the fastening nut. Push the ball into the socket and
tighten the nut again. You can loosen the nut at any time to
adjust the angle of the phone holder.
EN
143 mm
162.5 mm
concept manual_charger_EN_R4.indd 5
concept manual_charger_EN_R4.indd 5
11-03-20(W11) 10:53
11-03-20(W11) 10:53
