Pima Hunter-Pro 8144, Installation Manual

Page: 80 / 116

80 General Topics
Hunter-Pro Series & Captain 8 Installation Guide
There are over 30 “Output types” in the Hunter-Pro Series and Captain 8 systems. They are
allocated to the physical outputs in the “Outputs configuration” menu. See section ‎6.10.2.
8.3 System model & PCB version
The PCB/System model (832 or 8144) is printed on a colored label on the PCB's EPROM, a
different color to every model.
The overall number of zones and users is determined by the model type so, for example,
Hunter-Pro 832 cannot be expanded to more than 32 zones or users.
If the EPROM version and the system PCB version do not match, a “ System
Error ” is displayed; for example, the Hunter-Pro 8144 EPROM cannot be
used with the Hunter-Pro 832 PCB: c heck that the EPROM’s label color is
the same as the PCB s’ serial number.
8.4 Partitions
A partition (or "sub-system") is an area made of several zones that can be armed, while other
zones are not. In this way, only those zones that are part of the armed partition/s will activate
the alarm when they are opened; zones outside those partitions can be occupied at the same
time. There can be up to 16 partitions in Hunter-Pro Series and 4 in Captain 8.
In addition to zone partitions, PIMA’s systems provide keypad partitions as well: monitored
(addressable) keypads can be assigned to partitions and control (or display information about)
only zones that are part of these partitions.
Using partitions the alarm system can be split to 8 separate sub-systems including sirens in
Hunter-Pro systems and 4 in Captain 8. Users can be limited to some partitions, i.e., being
enable to arm & disarm only some zones.
S
E
T
C
O
N
T
IN
O
U
T
A
U
D
IO
TMPR2 TMPR1
ON/
OFF ALRM Z1 Z2 Z3 Z4 - + Z7 Z8 - + KEY
-
Int C
Z O N E S
Smoke
RELAY SIRENS KEYPAD
Ext N.O
-
- +
IN OUT 1 2 3 4 N.C Z5 Z6
L
IN
E
Output types: Burglary, Medical,
Anti mask, Panic, Mains fault,
Telephone line fault...