Pima Hunter-Pro 8144, Installation Manual

Page: 68 / 116

68 Programming the System
Hunter-Pro Series & Captain 8 Installation Guide
6.10.2 The Output Types
In PIMA alarm systems, "Output Types" are detected events that are used for triggering the
physical outputs. Each output can be triggered by only one output type, whereas the same
output type can trigger as much as all the physical outputs.
The following table describes the output types and their triggers.
[NEXT] Output type The event that triggers it
- External Siren
Zone alarm or system fault that are set to trigger the
"External Siren" output type as a response to alarm
X1 Internal Siren
Zone alarm or system fault that are set to trigger the
"Internal Siren" output type as a response to alarm
X2 Burglary Alarm in a “Burglary” zone
X3 Anti-Mask Alarm in an “Anti-Mask” zone
X4 Special Burglary 1 Alarm in a “Special Burglary 1” zone
X5 Special Burglary 2 Alarm in a “Special Burglary 2” zone
X6
Burglary - All
Types Alarm in “Burglary”, “Special Burglary 1” or “Special
Burglary 2” zones
X7 Fire Alarm in a “Fire” zone
X8 Special Fire Alarm in a “Special Fire” zone
X9 Panic
Alarm in a “Panic” zone, or pressing the panic key
combination [*]+[#].
X10 Silent Panic Alarm in a “Silent Panic” zone
X11 Hold-Up (Duress)
Alarm in a “Hold-Up (Duress)” zone, or entering
the “Duress” code
X12 Medical Alarm in a “Medical” zone
X13 Alarms - All Types Any alarm
X14 Audio Control Triggering an audio module: MIC-200 or VU-20N/U
X15 Zone Open Opening a zone (regardless of the panel status)
X16 Zone Bypassed Zone is bypassed by a user
X17
Smoke Detector
Power
Resetting smoke/fire detectors
X18 Tamper
Opening a tamper switch (connected via TMPR1/TMPR2
terminals)
X19 Zone tamper/fail Opening a zone tamper, or a zone failure
X20 Buzzer Activating the "Buzzer" output type
X21 Armed Arming the panel to any mode
X22 Installer Program Entering the Installer code
X23 General Fault AC, Low battery or Phone line faults occur
X24 Mains Fault AC fault occurs
X25 Low Battery Low battery fault occurs
X26 Phone Fault Phone line fault occurs
X27 GSM Fault GSM fault occurs
X28 Comm. Fault Communication fault occurs
X29 Not In Use -
X30 Door Code Entering the Door code