Pilz PSEN op3.1, Operating Manual, Page: 6 / 10

PSEN op3.1/3.2
Operating Manual PSEN op3.1/3.2
1003607-EN-02
6
a
Wire the outputs from the transmitter to the inputs provided on a safety light grid or con-
trol system for external muting sensors.
Transmitter
Assignment of the 4-pin
M12 male connector
1
2
3 4
PIN
1:
2:
3:
4:
Function
+10 ... 30 VDC
Test +
0 V
Test -
Wire colour
brown
white
blue
black
Installation and setting
General
}
Torque setting: Please note the information provided under Technical details [ 8] .
If necessary, the connector plug block can be rotated by 180°.
Pull the retention spring in the direction of the con-
nector (see diagram, [1]) and rotate the connector plug
block by 180°.
[1]
Setting
INFORMATION
The sensitivity controller can be rotated by a maximum of 240°.
If the trimmer is overwound the product will be destroyed.
– Never rotate the trimmer beyond the maximum position.
1. Set the sensitivity controller on the receiver to the highest level.
2. Position the transmitter and receiver on the muting sensor opposite each other in paral-
lel, in the required position in relation to the light grid. In both positions, a mounting sur-
face must be available, to which the transmitter and receiver can be attached.
3. Move the transmitter and receiver horizontally and vertically until the orange LED illu-
minates and then goes out. Attach the transmitter and receiver in the middle between
these points.
}
If the muting sensors are to detect small objects, the sensitivity of the receiver can be
reduced.