PILOTAGE NANO-X, User Manual

Page: 19 / 40

www.pilotage-rc.ru
18
FAQ
1 . Transmitter and X4 will not bind .
Answer: Throttle position needs to be fully minimized . Please do not move the transmitter sticks or trims
during initial power-on binding .
2 . Gyro not working well
Answer: (1) Battery voltage too low . (2) Re-bind (3) Land on to the ground with the throttle fully minimized
for 3 seconds and take off again .
3 . Unable to Flip
Answer: (1) Press the Elevator stick one time to enter into the expert(flip) mode . (2) In the expert(flip) mode,
the sensitivity on each channel should be above 90%, you can program the sensitivity in the setup menu .
Please check manual 4 .4 Stick Sensitivity Adjustment . (3) Press the throttle stick to turn off anti-flip . (4) Lipo
power is too low and needs to be recharged .
4 . Quadcopter is shaking or oscillating with noise .
Answer: Please check to see that the motors, canopy, body and props are all properly positioned .
5 . Switching between low and high rates on the transmitter not very user-friendly .
Answer: Press the Elevator stick briefly only one time to switch on/off the expert mode(red flashing TX LED)
and normal mode(green solid LED) . The word “Expert” will also appear at the bottom center on the LCD .
6 . Can not take off .
Answer: (1) Wrong installation of the props . Props are marked with “A”(CW) and “B”(CCW) . Please check the
pictures below for the correct order . (2) Wrong installation of motors . Please check to make sure that each
motor is installed in its correct position . There are two different types of motors with different motor wire
colors . Please check the pictures below for the correct order .
7 . One or more motors stop working
Answer: (1) Motor is damaged . Replace the motor . (2) The motor connections(s) are disconnected . Resolder .
(3) An FET on the flight controller looks burned . Replace the flight controller .
(Top View) (Bottom View)
Blue
Blue
Red
Red
White
White
Black
Black