Rudder Servo Installation:
Elevator Servo Installation:
Locate and cut the covering where the servo will be installed, at the rear of the
fuselage, under the elevator.
Route the servo wire through the wing and screw the servo in place.
Centre the servo with your transmitter, attach the servo arm and connect the servo to
the ailerons with the pushrods provided.
Centre the servo, attach the servo arm and connect the pull-pull wires to the servo
using the accessories included, securely crimping the wires with the brass tubing,
then cover with heat shrink.
Position the other end of the wires through the rudder horn, pull the wires tight and
crimp as before.
Fine adjustments can be made from the threaded rod connected to the ball links.
