Pilot Communications 70268, User Manual

Page: 23 / 24

11
EN
Increase the revolutions up to 2500-3000 r / min
by holding them for about 5 seconds and press
ENTER to continue.
Charging Test
Testing
********************
Charging Test
Increasing RPM to
2500/r/min and keep it
5 seconds.
At the end of the test, one of the following results will be
displayed:
Charging Test
Loaded: 14,20V
Unloaded: 14.40V
Ripple: 15mV
Charging normal
Voltage OK
The vehicle's charging system is working properly.
LOW voltage
The charging system does not charge the battery sufficiently
or check the consumption of the connected accessories.
Have the vehicle checked by a repair center.
Charging Test
Loaded: 14,20V
Unloaded: 14.40V
Ripple: 15mV
LOW voltage
HIGH voltage
The vehicle's charging system produces too high a charging voltage.
Have the vehicle checked at a repair center.
PLEASE NOTE: For Star & Stop vehicles a higher charging voltage around
15V ± 0.5V is normal. Check the manufacturer's specifications for the
correct limit, as it will vary by vehicle type and manufacturer.
Charging Test
Loaded: 14,20V
Unloaded: 14.40V
Ripple: 15mV
HIGH voltage
PLEASE NOTE: If the alternator is completely broken or not connected
to the battery, the test will be repeated 3 times after which it will show
No voltage.
Check the alternator or the connection with the battery and repeat
the test.
Charging Test
Loaded: 14,20V
Unloaded: 14.40V
Ripple: 15mV
No voltage
3 Battery out of the vehicle
This test allows you to check the batteries not connected to the vehicle.
Follow the same instructions as for: Battery In Vehicle / Battery Test.