Pilot Communications 70268, User Manual

Page: 22 / 24

10
EN
2.2 Cranking test
Then start the engine and the
test will start automatically.
Cranking test
Testing
********************
Cranking test
RPM Detected
Cranking test
Start Engine
At the end of the test the result will be shown. Normally, a
starting voltage value lower than 9.6V indicates a malfunction of
the battery that must be replaced, while values higher than 9.6V
are correct.
The test result of the tester includes the actual starting voltage
and the actual starting time.
Cranking test
Times: 20ms
Cranking: OK
10.07V
Cranking test
Times: 20ms
Cranking: LOW
8.05V
When the cranking has problems, the test result will still be shown.
NOTE: after the test, press the EXIT key to exit or press the ENTER
key to perform the LOAD TEST.
2.3 Charging test
Turn on the engine. Turn OFF the air conditioning, lights and all
other devices / accessories connected to the vehicle and wait
10 seconds. Continue by pressing ENTER.
Charging Test
Start Engine
A ripple test will be performed immediately for about 6 seconds
where the ripple values and the charging voltage will be shown.
At the end the test will continue automatically.
Charging Test
Ripple test
-----------------------------
35mV 14.32V
Charging Test
Testing
********************
The test will read the charging voltage for approximately
3 seconds.