Pikkerton XBS-200, User Manual, Page: 8 / 21

XBS-200
User Manual
Version 02
1.3 Reset
The XBS-200 can be restarted using the button or a software command.
- Button
The device has a button with which measurements and a reset can be triggered. To initiate a
reset, press the button for at least 10 seconds. All LEDs on the device go out. The XBS-200
restarts, the blue LED1 lights up during the boot phase.
- Software
The device can be restarted via the console using the reset command
console> reset
The XBS-200 acknowledges this with:
Restarting XBS-200!
The XBS-200 restarts, the blue LED1 lights up during the boot phase.
- USB
If the XBS-200 is operated with batteries, a reset is necessary to activate the USB interface.
USB is deactivated in battery mode to save power.
Connect the USB cable to the PC and the XBS-200 and trigger a reset with the button. After
the reset, the XBS-200 starts in USB mode. If the USB cable is removed, the XBS-200
automatically triggers a reset to restart in battery mode.
1.4 LEDs
The XBS is equipped with 2 RGB-LEDs.
Solid On Flashing
LED1 Red Could not send data to broker (MQTT)
LED1 Green Data sending OK (MQTT)
LED1 Blue Booting
LED2 Red
LED2 Green
Measurement in progress
LED2 Blue
1.5 Pushbutton
A short push onto the button starts a new measurement interval, regardless of the TXT or MSI cycle.
All sensor values are going to be transmitted immediately. Pressing the button longer than 10s causes
a hardware reset / restart.
© 2020 pikkerton GmbH XBS-200_Manual_v02.odt Page 8/21