7
www.pifco.co
Assembly of your fan:
Before using, there is some assembly required
as follows:
1.
Place Part A of the stand base into Part B
of the stand base to form an ‘X’ shape.
2.
Place the plastic base pipe onto the
X-base you have just created,and fix it
with the four screws provided.
3.
Attach the stabilising feet onto each of
the four ends of the ‘X’base,making sure
they are firmly secured.
4.
Slide the metal pipe into the plastic
base pipe.
NOTE:
This pipe has a slight
lip at one end; ensure this end is facing
upwards when you slide the pipe through,
as the lip will help secure it in place.
5.
Tighten the height-adjusting screw so
that the metal pipe is secured in place.
6.
Loosen and remove the pipe connector
from the lower pipe. Slide the
NOTE:
We recommend performing the
following on a worktop or other suitable
sturdy work area.
7.
Attach the motor onto the upper
pipe. Ensure the speed regulation
compartment on the motor is pushed all
the way inside the upper pipe.
8.
Fasten the speed regulation compartment
to the pole with the provided screw.
Ensure that this is tight.
9.
Place the fan on a table, face up. DO
NOT place the fan upside down as the
cover can be damaged.
10.
Loosen the guard mounting nut from the
motor housing.
11.
Position the rear guard firmly against the
motor housing. You will recognise this
guard by the built-in metal handle at its
top.
12.
Fasten the rear guard by turning the
guard-nut cover clockwise.
1
1
3
5
2
2
4
6
A
B
C
Note:
Make sure that the fan is on a level
surface and away from any liquids.
Oscillating the fan will create a more
uniform cooling effect in the room.
