
HOW TO USE HAND - HELD STEAMER
CAUTION
Make sure that the Steam Mop is unplugged.
1) Fill the Water Tank wit water. Please refer to the "HOW TO USE THE STEAM
MOP" section in this manual.
Attach either the round nylon brush or the round copper brush as explained in the
"How to assemble Hand-Held Steamer" section in this manual.
2) Select one of the following Steam Regulator positions: 1 - Low, 2 - Medium, 3 -
High or 4 - Hot Spray. You can change the Steam Regulator position and the steam
output while operating the Steam Mop.
3) Once the unit has been fully assembled and filled with water, plug in the Power
Cord into a grounded electrical outlet. RED light - Power Indicator will indicate when
power is on. Power Switch ( O/I ) is in the OFF ( O ) position ( higher position ). Wait
for the Ready - to - Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use. When the Ready to
Use indicator light turns green press the Power Switch ( O/ I ) to the ON (I) position
( lower position ). The Hand -Held Steamer will start emitting steam. To stop emit-
ting steam, turn OFF the unit by pressing the Power Switch (O/I) again.If the Power
Switch (O/I) is pressed ( lower position ) prior to the Ready - to - Use light indicator
turning green, water from previous use will not be heated and will be forced out by
present steam.
This may also happen if the Power Switch (O/I) was left in the ON (I) position
(lower position) after previous use and the unit was disconnected by unplugging only.
Make sure to turn the unit off after each use and then disconnect from the electrical
outlet so the unit is in the OFF (O) position when used next time.
4) Slowly pass over surfaces to be cleaned. Apply steam liberally. Keep a towel handy
and wipe away any excess water that may accumulate.
5) When the Hand - Held Steamer stops emitting steam, simply turn OFF and unplug
the unit, refill the Water Tank and continue cleaning.
To sanitize your work surfaces, kitchen counter tops, sinks, bathrooms,etc. use the
Hand - Held Steamer over the same area for about 15 seconds.
NOTICE
Do not carry out this procedure on heat and steam sensitive surfaces.
The force and heat of the steam may adversely affect certain materials. Always check
the suitability of using the steamer on a particular surface by first testing a hidden
area
• Do not use the steam to clean frozen windows.
• Be careful when using the steamer on glass, as it may break.
• Do not use steamer on leather, wax polished furniture or waxed floors, synthetic
fabrics, velvet or other delicate steam - sensitive materials.
.
WARNING
Never direct steam towards people, animals or plants.
AFTER USE
1) Unplug Power Cord from outlet.
2) Allow Mop Pad / Cloths to cool down and carefully remove cleaning cloth from
Mop Head, as cleaning cloth could still be hot.
3) Any water remaining in the Water Tank should be emptied prior to appliance stor-
age. Always empty the Water Tank at the end of each use.
4) Let any water (that may remain as a product of condensation) drain from the
steam opening prior to storing the appliance.
5) Wrap Power Cord around Upper and Lower Cord Wrap.
6) Wipe all surfaces of the Steam Mop with a soft cloth. Store in a protected, dry
area.
7) Please store the unit in a cool and dry place when not in use. Do not leave it
exposed to sunlight or rain.
8) Upright storage of the Steam Mop with a wet Mop Pad / Cloth may result in the
formation of white marks on your floor. To remove the white marks, clean area with
vinegar. Make sure to remove the Mop Pad / Cloth before storage.