Tel: +49(0)3641/66880 • Fax +49(0)3641/668866 •
• www.piezosystem.de
27
7.8. Wiring of the rear panel connector
To realize OEM applications, all main control signals are available at the rear
panel connector too.
Pin
name
description
1,4
GND
ground (Signal)
2
VCC
+5V output, for switching SRC
6
MON
monitor signal 0...+10V
7
MOD
modulation input 0...+10V
8
SRC
source, choice of the amplifier control by HIGH or LOW
TTL level
HIGH: Pin 7 is active, OFFSET potentiometer and MOD
(modulation input) at the front panel are switched off
LOW: Pin 7 is not active, motion of the actuator will be
controlled by the OFFSET potentiometer and the MOD
(modulation input) at the front panel
12
OUT
output voltage Uout -
10…+150V (* option)
15
GND
ground (operating voltage)
16
PWR
+ operating voltage
table 2: pin wiring of the rear panel connector (12V40 / SG / CLE)
* option: is set at the factory, must be specified when ordering
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
