Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
28
7.8. Wiring of the rear panel connector
To realize OEM applications, all main control signals are also available at the
rear panel connector.
Pin
name
description
1,4
GND
ground (Signal)
2
VCC
+5 V output, for switching SRC
6
MON
monitor signal 0...+10 V
7
MOD
modulation input 0...+10 V
8
SRC
source, choice of the amplifier control by HIGH or LOW
TTL level
HIGH: Pin 7 is active, OFFSET potentiometer and MOD
(modulation input) at the front panel are switched off
LOW: Pin 7 is not active, motion of the actuator will be
controlled by the OFFSET potentiometer and the MOD
(modulation input) at the front panel
12
OUT
output voltage -
10…+150 V (* option)
15
GND
ground (operating voltage)
16
PWR
+ operating voltage
table 2: pin wiring of the rear panel connector (12V40 / SG / CLE)
* option: is set at the factory, must be specified when ordering
