Manual PIEPS iPROBE BT | 08/2020
16 / 17
6.
TROUBLESHOOTING, MAINTENANCE, STORAGE, DISPOSAL
TROUBLESHOOTING
When the PIEPS iPROBE BT shows no indication when switching on or a system error is indicated after the self-
check., perform the following instructions:
1)
Deactivate the PIEPS iPROBE BT (remove tension and fold the tubes)
2)
Check the PIEPS iPROBE BT for physical damage.
3)
Check the battery capacity, type and polarity (+,-). Replace the battery.
4)
Activate the PIEPS iPROBE BT again.
5)
Perform a device-check in the PIEPS APP.
If the PIEPS iPROBE BT still shows no indication or a system error, please take the device to your retailer or
contact our support (
) .
BATTERY REPLACEMENT
The PIEPS iPROBE BT analyses the charge remaining in the battery each time the probe is switched on. If the
charge reaches a critical level, a warning will be indicated after the self-test for 3 seconds.
PIEPS recommends replacing the battery immediately, even though there should be enough power left for
another 1 - 3 rescues.
Replace the battery as follows:
•
Unscrew the cover of the battery compartment anticlockwise (3A).
•
Replace the battery with 1x Alkaline, AA, LR6, 1,5V. When installing the new battery, make sure the
polarity is correct (3B).
•
Dispose of the battery in accordance with the law in your country.
DANGER
Risk of explosion from incorrectly used batteries.
Risk of incorrect battery capacity indication.
Only use batteries of type
„Alkaline, AA, LR6, 1,5V“!
3A
3B
Summary of Contents for iPROBE BT 220
Page 1: ...ENGLISH 08 20...