Picote Solutions Oy Ltd
9
OPERATING INSTRUCTIONS
Before operation:
•
Before installing Smart Heat cable inside the pipe, always make sure that the
machine is fully turned off and unplugged to avoid burn injuries.
•
Always check the condition of the cable casing before using the machine for any
signs of wear and tear.
•
The heating cable can be guided directly through the curing cap without need to decompress the lining during
the process.
While in operation:
•
Always lay the machine down horizontally on the floor.
STARTING & USING THE MACHINE
This section contains important safety information. Failure to comply could result in serious injury.
1.
Shoot the lining inside the pipe.
2.
Place the curing cap in the end of the lining. Liner compressor can be used to prevent the lining from col-
lapsing during this step.
3.
Plug the compressed air hose to the curing cap and remove liner compressor.
4.
Push the Smart Heat cable through the curing cap.
5.
Release E
-
Stop Button and turn power switch to ON position.
6.
After the lining is cured, pull the heating cable to the reel, remove curing cap and finish off the end of the
lining.
The heating cable used into the Picote Smart Heat Millers is self
-
adjusting. Heating element observes the temper-
ature constantly and prevents the temperature to rise above +60
o
C (+140 F) in the pipe thus preventing any dam-
ages to the lining. The heating cable is water
-
proof.
