OPERATING AND INSTALLATION INSTRUCTIONS LBE 250 / LBE 500
PAGE 32
US
ER
G
ENER
A
L
S
PE
CI
A
LI
S
T PER
S
O
NNEL
Connection diagram parallel circuit
with thermostatic valve:
With this
connection variant the system can be
best coordinated and regulated. The heat
output of the reheating coil is automati-
cally adjusted by the „
thermostat valve*“
to the integrated heater, with that the
highest possible evaporation line is
obtained in connection with the available
flow temperature.
The
„thermostat sensor*“
must be ins-
talled in the feed line approx. 50 cm next
to the reheating coil.
Feed line
Return line
Air inlet
Heating
system
On site
*
Connection diagram serial connection
(with bypass):
This connection method
has the disadvantage that the heat
output of the heater cannot be controlled
separately. Should the heat output of
the reheating coil be too high, the mixer
is added and reduces the heat output
of the integrated heating coil and the
humidification.
By installing a bypass line with a control
valve, the heat output can be adjusted to
both heating coils.
Feed line
*
Return line
Air inlet
Heating
system
External temperature sensor
