Piazzetta MARCELLA, Instructions For Installation, Use And Maintenance Manual, Page: 31 / 52

DT2011657-00
6.10 bUzzER ENAbLE
DT2011658-00
6.11 dISPLAy MOdE
This function is used to enable or disable the warning signal emitted if a safety device is activated.
This function is used to display the room temperature or the time on the display.
Description of activity Display
Press key 6 for a few seconds. Use key 5 or 6 to scroll the menu that appears on the
display until the scrolling readout BUZZER ENABLE appears.
Confirm by pressing the SET key.
BUZZER ENABLE
Use key 1 or 2 to select on the display the option ON to enable the buzzer or OFF to
disable.
Confirm by pressing the SET key.
ON MODE
BUZZER
After confirmation the scrolling readout “FUNCTION ENABLED” appears on the display
and the display then returns to its original status.
FUNCTION ENABLED
Description of activity Display
Press key 6 for a few seconds. Use key 5 or 6 to scroll the menu that appears on the
display until the scrolling readout MODE DISPLAY appears.
Confirm by pressing the SET key.
MODE DISPLAY
Use key 1 or 2 to select on the display the option TEMP (enabling room temperature
display) or HOURS (enabling timetable display).
Confirm by pressing the SET key.
HOUR DISPLAY
After confirmation, the scrolling readout “FUNCTION ENABLED” appears on the display
and the display automatically returns to its initial status.
FUNCTION ENABLED
DT2010082-04
6.12 LIGhTING FOR ThE FIRST TIME
- Carefully read this “Instructions for installation, use and maintenance” in its entirety before lighting your stove for the first time.
- Before lighting the stove for the first time, check that the grate is properly placed and pushed towards the left.
- There will be odours when lighting the first few times due to the evaporation of paints and oils used during the manufacturing process.
During this stage, air the room well where the stove is installed and avoid staying there any length of time since the fumes being given off could be
harmful to persons or pets.
The stove body should have settled down and the paints fully evaporated after having lit the stove a few times.
To this end, follow the instructions given below when using the stove.
- Operate at medium power for the first 5-6 hours after igniting the fuel (the expansion caused by the heat during this stage will allow the stove body
to settle).
- After the settling-down stage the stove must be set to operate at maximum power for a period between 6 and 10 hours, depending on the amount
of paint on the stove body that must be evaporated off.
The time indicated for operation at maximum power does not necessarily have to be continuous, but may be divided up into two periods separated by
an interval of at least 3-4 hours with the stove shut down.
At the end of the recommended period the paint will have evaporated and the stove should be used at the suitable power for normal use.
If necessary the stove may be used for a further period at maximum power to ensure complete and final disappearance of all paint residue.
When the hopper is being loaded for the first time the loading auger needs time to fill up; during this stage the pellets are not distributed inside the
firebox and it is highly probable that the first attempt at ignition fails. If the alarm is activated, shut down the stove by pressing the ON/OFF key for a
few moments, remove the fuel in the grate and then set the stove for a new ignition process.
H07029330 / DT2001081 – 02 31
English