03_01
03_02
03_03
Engine oil level
In 4T engines, engine oil is used to lubricate the distribution elements, main bearings
and thermal group.
An insufficient quantity of oil can cause serious damage to
the engine itself.
In all four-stroke engines, a loss of efficiency in oil performance and
consumption should be considered normal. Consumption can particularly reflect the
conditions of use (i.e. when driving at "full acceleration" all the time, oil consumption
increases). The replacement frequencies provided for by the maintenance programme
are defined, depending on the total contents of oil in the engine and average con-
sumption measured following standardised methods.
In order to prevent any prob-
lems, we recommend checking oil level more frequently than indicated in the
Scheduled Maintenance table or before setting off on long journeys. The vehicle
is, however, equipped with an oil pressure warning light on the instrument pan-
el.
Engine oil level check (03_01, 03_02)
Every time the vehicle is used, visually inspect the level of the engine oil when the
engine is cold (after
completely unscrewing
the oil cap/dipstick). The oil level should
be somewhere between the MAX and MIN reference marks on the dipstick «
A
»; during
the oil check, the vehicle must be resting on its centre stand on an even, horizontal
surface.
If the check is carried out after the vehicle has been used, and therefore with a hot
engine, the level line will be lower; in order to carry out a correct check, wait at least
10 minutes after the engine has been stopped so as to get the correct level.
Engine oil top-up
Always check oil level before topping-up and add oil
without exceeding the MAX
level
. Getting an oil level between the
MIN
and
MAX
levels requires ~ 200 cm³ of oil.
Take your vehicle to an
Authorised Service Centre
to have the engine oil checked
and if necessary, topped-up as indicated in the scheduled maintenance table.
Warning light (insufficient oil pressure)
The vehicle is equipped with a warning light that lights up when the key is turned to
the «
ON
». However, this light should switch off once the engine has been started.
If
the light comes on while braking, at idle speed or while turning a corner, it is
42
3 Maintenance
Summary of Contents for xevo 250IE
