PIAGGIO X8 250 i.e, Manual

Page: 66 / 92

03_28
03_29
Headlightadjustment (03_28, 03_29)
Proceed as follows:
1. Position the unloaded scooter, in running order and with the tyres inflated to the
prescribed pressure, on a flat surface 10 m away from a half-lit white screen; ensure
that the longitudinal axis of the scooter is perpendicular to the screen;
2. Turn on the headlight and check that the borderline of the projected light beam
should be lower than 9/10 of the distance from the ground to the centre of the vehicle's
headlight, and higher than 7/10;
3. If not, adjust the projection by turning the central screw «A» set inside the glove
box.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE VE-
HICLE IS USED.
03_30
Frontdirectionindicators (03_30, 03_31, 03_32)
To replace a burst bulb:
1. Remove the driving mirrors, by lifting the cover and loosening the two screws " A "
on both sides.
2. Remove the front turn indicator light assembly cover, by loosening the four fixing
screws " B ".
3. By loosening the two fixing screws " C " remove the turn indicator light;
To reassemble, repeat the operation in the reverse order.
66
3 Maintenance