PIAGGIO Beverly 400 I.E, Manual

Page: 42 / 82

03_09
03_10
Spark plug dismantlement (03_09, 03_10)
Remove the port on the left-hand side panel of the vehicle by undoing the fixing screw
«
A » and using a small screwdriver in the rear notch shown in the figure, then proceed
as follows:
1. Disconnect spark plug HV wire cap « B » ;
2. Unscrew the spark plug using the wrench supplied. ;
3. When refitting, place the spark plug in the hole at the due inclination and tighten it
by hand until it is finger tight;
4. Only use the wrench to lock it in place;
5. Place cap « B » fully over the spark plug.
6. Refit the port making sure the rear hook is inserted.
WARNING
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. RE-
PLACE THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAINTENANCE
TABLE. THE USE OF ELECTRONIC CENTRAL UNITS AND OF NON-COMPLIANT
ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRESCRI-
BED MAY SERIOUSLY DAMAGE THE ENGINE.
N.B.
THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF
SHIELDLESS SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAIL-
URES.
Characteristic
Spark plug
CHAMPION RG 6 YC
Alternative spark plug
42
3 Maintenance