PIAGGIO Beverly 400 I.E, Manual

Page: 17 / 82

Insert the «MASTER» key « A » into the key switch (in « OFF ») and turn it to « ON ».
After 1 - 3 seconds, turn the key to « OFF » again and pull it out.
INTERMEDIATE STAGE
After extracting the «MASTER» key « A », insert, within ten seconds, the key that is
going to be programmed « B » and turn it immediately to « ON ». After 1-3 seconds, turn
the key to « OFF » again and pull it out. In this way, a maximum of 7 keys can be
programmed by repeating the above procedure and keeping the indicated times.
FINAL STAGE
After extracting the key to be programmed « B », insert the MASTER» key « A » again
and turn it to « ON » (perform this operation within the 10 seconds following the ex-
traction of the previous key). Leave it in this position for 1 to 3 seconds and return it
to the «
OFF » position.
CORRECT PROGRAMMING CHECK PHASE
Insert the «MASTER» key « A » disabling the transponder « C » (i.e., by tilting the key
cap by 90°), and turn the key to « ON ». Perform the engine start-up operation. Ensure
that the engine does not start. Insert the programmed key « B » and repeat the start-
up operation. Check that engine starts.
WARNING
SHOULD YOU STAR THE ENGINE WITH THE MASTER KEY (WITH TRANS-
PONDER OFF) OR IN THE EVENT OF WRONG OPERATION DURING PROGRAM-
MING, REPEAT THE PROCEDURE FROM THE BEGINNING.
17
1 Vehicle