-7-
PKI-0081
** Do not use driving lights into
oncoming
traffi
c.
Driving lights should never be
the only forward light source.
Driving lights should only be
used with the headlamp high
beams.
1.5
DRIVING Light lamp aiming
Troubleshooting……
Verify each section according to the following.
Typically, driving lights are mounted above the front bumper about 30 inches(76cm) from the ground to provide extra high
beam illumination. Driving lights can be mounted below the bumper, although they will not be as eff ective because the
light will hit the ground sooner and reduce the range of the light.
Visual aim is made with the center of the beam hot spot 1.5 inches(4cm) below the lamp center at 25feet(7.6m) with the
lamp facing straight forward. (see below.)
1
After installation, if the lamp does not activate
●
Check the wiring and make sure there are no faulty or incorrect connections .
2
If the LED suddenly fails to light up …
●
Check the fuse located on the vehicle's wiring system. If the fuse is burned out, read below [3] Before
replacing the fuse, then replace with an equal ampere fuse
●
Check the fuse for the switch harness. If the fuse is burned out, read below [3] Before replacing the fuse,
then replace with an equal ampere fuse.
●
There may be cases where each terminal related to specifi c sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
●
Check if the switch unit operates normally. If not, replace the switch unit.
3
Before replacing the fuse
●
A short circuit may have occurred. Check the wiring system. If any type of damage is found, replace the wiring
system.
（
Non replacement may pose potential danger
）
(Short circuits are mainly
caused when wires are
incorrectly connected or when there is a gap in the sleeve connected to the lamp harness).
